MENU DESCRIPTION
The Array EQ value can be read on the top of the LCD screen for each channel (unit is dB).
To change the Array EQ for a given channel, select the channel first by pressing the
corresponding “select” button. The channel name on screen will then be put between
bracket (see on the picture above, channel 2 is selected). Then turn the wheel to change
the Array EQ setting (from – 6 dB to + 6 dB).
You can select multiple channels by pressing several “select” buttons at the same time.
When a selected channel reaches the maximum value, it will cease to increase by
continuing to turn the wheel, but other selected channels may still increase the setting: be
careful not to change a gap between two channel settings when selecting multiple channels
at the same time..
In some special circumstances (cardioids setups for example) it is mandatory to have same
Array EQ settings on two or more channels. Then, changing the Array EQ on one of these
channels will automatically adjust the Array EQ on the other channels.
Options Menu
With this menu you can enter some sub-menu to adjust parameters of the NXAMP does do
not need to be changed during the normal use of the amplifier (mainly during setup of the
unit only). Bellow is a picture of this menu.
The sub-menu located on the top of the screen will blink (here it is 1.Systm Config).
Depressing “select” of channel 4 will enter this sub-menu (“OK” is displayed on the screen
align with “select” 4 button). Turn the wheel to select another sub-menu. When coming
back to the Options menu later, the last selected sub-menu will be displayed first.
System config
This menu allows changing between several speaker setups inside a same family. Same
PAGE 40 OF 80
To Next Page
Loading...
Need help?
General
