NXES104 EXPANSION BOARD AND REMOTE CONTROL
(4) Security
This control is not accessible with this release: Security settings are not yet implemented .
However, you can use the security settings from the ESmonitor software itself, allowing
several users to have access to the Ethersound™ network with different level of security.
Please refer to the ESmonitor User Manual for details.
(5) Volume control
This button can set up the volume for each channel of the NXAMP. To adjust the volume
with this virtual pot, you can click and drag the button itself or simply use the mouse wheel
while you are on the virtual pot area.
N.B.: On some setups the volume settings may be linked.
(6) Gain control
To adjust the gain on one channel, click and drag the virtual fader. You can also simply
goes onto this control and use the mouse wheel.
N.B.: On some setups the volume settings may be linked.
(7) Output meters
For each channel there are two output meters; the left one is showing the output voltage,
whether the right one is showing the output current.
(8) Mute button
Click on this button to mute or unmute a channel.
(9) Delay settings
Use the small buttons bellow the text box to increase or decrease the delay settings for
each channel. You can also directly enter the delay value in the text box.
N.B.: On some setups the delay settings may be linked.
(10) Input patch
For each channel, you can see eight buttons corresponding to the eight available inputs (4
analog and 4 digital). Click on the button to patch or unpatch an input. If the button is
dark, it means that the input is patched, if not it is white.
N.B.: On some setups the input patch may be linked.
(11) ArrayEQ settings
To adjust the ArrayEQ on one channel, click and drag the virtual fader. You can also simply
PAGE 58 OF 80
To Next Page
Loading...
Need help?
General
