53
Features That Can Be Set Using the Multi Selector
Shooting Features
Using the Flash (Flash Modes)
The flash mode can be set to match the shooting conditions.
1 Press the multi selector H (m flash mode).
2 Press the multi selector H or I to choose the
desired flash mode and press the k button.
• See “Available Flash Modes” (A54) for more
information.
• If a setting is not applied by pressing the k button
within a few seconds, the selection will be canceled.
• When U (Auto) is applied, D is only displayed for
a few seconds, regardless of Photo info settings
(E53).
3 Frame the subject and take a picture.
• The flash lamp indicates flash status when the shutter-
release button is pressed halfway.
- On: The flash will fire when you press the shutter-
release button all the way down.
- Flashes: The flash is charging. Wait a few seconds
and try again.
- Off: The flash will not fire when a picture is taken.
• If the battery is low, the monitor will be turned off while the flash is charging.
C Effective Range of the Flash
When ISO sensitivity is set to Auto, the flash has a range of 0.5–4.5 m (1 ft 8 in.–14 ft) at the
maximum wide-angle zoom position and a range of 0.5–2.4 m (1 ft 8 in.–7 ft 10 in.) at the maximum
telephoto zoom position.
Auto
To Next Page
Loading...
Need help?
General
