Nikon Speedlight SB-700 User Manual

D–28
Wireless Multiple Flash-unit Photography
D
Master
 ash unit
Remote  ash unit
Speedlight status
Flash-ready
indicator
Flash-ready
indicator
Sound
monitor
Blinks for
approx.
3 sec.
Quickly
blinks for
approx.
3 sec.
Three long
beeps for
approx.
3 sec.
Insuf cient  ash output for
correct exposure
*1
Underexposure due to insuf cient
 ash output may have occurred.
To compensate, use a wider
aperture or higher ISO sensitivity,
or move the  ash unit closer to
the subject and reshoot.
Goes out
and lights
up when
ready to  re
Quickly
blinks for
approx.
6 sec.
High and
low tone
beeps
alternate
for
approx.
6 sec.
• Auto aperture  ash mode or
non-TTL auto  ash mode is
set on the master  ash unit.
Change the  ash mode to an
operable  ash mode.
• The remote  ash unit light
sensor has failed to receive the
command light from the master
 ash unit. This is because the
light sensor cannot detect when
to stop  ring in sync with the
master  ash unit, either due to a
re ection from the remote  ash
unit itself or light from another
remote  ash unit that may
have entered the light sensor
window. Change the direction
or position of the remote  ash
unit and reshoot.
Checking Status in Wireless Multiple Flash-unit Photography

Nikon Speedlight SB-700 Specifications

General

Vari-Power	1/1 to 1/128
Type	Shoe Mount
Color Temperature Information Communication	Yes
LCD Panel	Yes
Guide Number	28 m/92 ft at ISO 100 (35mm)
Zoom Range	24-120mm
Flash Duration	1/1042 sec at full power
Exposure Control	i-TTL
Bounce Head	Yes, -7 to 90 degrees
Swivel Head	Yes, 180 degrees left or right
Power Source	4 x AA batteries
Weight	360 g without batteries
Recycle Time	2.5 sec (NiMH)
Flash Modes	TTL, Manual, Repeating
Wireless Operation	Yes; Commander and Remote modes