Nikon Z 7 User Manual

78 Shooting Controls
Auto ISO Sensitivity Control
In modes P, S, A, and M, auto ISO
sensitivity control can be enabled or
disabled by holding the S button and
rotating the sub-command dial. When
auto ISO sensitivity control is enabled,
ISO sensitivity will automatically be
adjusted if optimal exposure cannot be
achieved at the value selected with the
S button and main command dial. To
prevent ISO sensitivity going too high,
you can choose an upper limit of from
ISO 100 (Z 7) or 200 (Z 6) to Hi 2 using the
ISO sensitivity settings > Maximum sensitivity item in the
photo shooting menu.
When auto ISO sensitivity control is enabled, the shooting
display will show ISO AUTO and control panel ISO-A. When
sensitivity is altered from the value selected by the user, the
altered value is shown in the display.
Monitor Control panel
D Auto ISO Sensitivity Control
If the ISO sensitivity selected by the user is higher than that chosen for
Maximum sensitivity when auto ISO sensitivity control is enabled,
the value selected by the user will be used instead. When a flash is
used, shutter speed will be restricted to values between the speed
selected for Custom Setting e1 (Flash sync speed) and the speed
selected for Custom Setting e2 (Flash shutter speed).
Sub-command dial
S button

Nikon Z 7 Specifications

General

Camera Type	Mirrorless
Sensor Resolution	45.7 megapixels
Sensor Type	CMOS
Image Processor	EXPEED 6
Lens Mount	Nikon Z mount
ISO Range	64-25600 (expandable to 32-102400)
Continuous Shooting	9 fps
Video Resolution	4K UHD at 30p
Battery	EN-EL15b
Weight	675 g (body only)
Dimensions	134 x 100.5 x 67.5 mm
Weather Sealing	Yes
Sensor Size	35.9 x 23.9 mm
Shutter Speed	1/8000 to 30 seconds
Viewfinder	Electronic, 3.69 million dots
Screen	3.2-inch tilting touchscreen, 2.1 million dots
Autofocus System	493-point phase-detection
Image Stabilization	5-axis in-body stabilization
Storage Media	XQD card slot
Battery Life	Approx. 330 shots