58
Troubleshooting
Emergency operation
Emergency operation domestic hot water
If an error occurs in the controller or components in the Compact P, and the unit therefore stops, it will not be able to produce domestic
hot water.
If the installer is not able to come right away or the error happens outside the opening hours, and you therefore cannot contact the in-
staller, there is a possibility to get hot water by setting the unit into emergency mode.
The button for emergency operation is located
behind the large door.
The emergency operation has three settings:
I - Auto:
El-supplementation is controlled by the control in the unit (standard set-
ting).
0 - Off:
El-supplementation is off and cannot be turned on again by the control in
the unit.
II - Manuel:
El-supplementation is turned on, and cannot be turned off by the control in
the unit (Do not turn it on if there is no water in the tank).
WARNING
In manual operation, the water temperature can achieve 75 °C, which can cause scalding, if you are not careful when
you open the hot water.
To Next Page
Loading...
Need help?
General
