Notifier ID50 SERIES User Manual

ID50 Series Panel - Operating Manual
Operator Actions at Panel
28997-264-000-8, Issue 8
January 2007
[U0 Disable/Enable] 1:Zone 2:Outputs
3:Day Mode 4:Delays
[Disable/Enable] Zone _ _
Enter Zone Number < : Cancel
1
4.10 DISABLE / ENABLE - User Option
This option allows the user to disable or enable (depending
on their current state) the following parts of the system:
a. Zone (Device or Full Zone).
b. Outputs.
c. Day Mode.
d. Delays.
To display the DISABLE/ENABLE menu:
1 At the ‘Status: NORMAL’ message, press the ‘ ’
button. The LCD prompts for a Level 2/3 access code.
2 Either turn the keyswitch or, using the numeric keypad,
enter the correct Level 2 access code and confirm
using the ‘
5
’ button to display the menu. The LCD
displays the user number ([U0] to [U9]) in the top left-
hand corner.
Note: An incorrect access code causes the LCD to
display the ‘ERROR - INCORRECT PASSCODE’
message. After one minute the LCD returns to the
‘Status: NORMAL’ message.
3 Using the numeric keypad, press the ‘
2
’ button to
display the DISABLE / ENABLE menu.
4.10.1 Zone - User Option
This option allows the user to disable/enable a full zone or
part of a zone (selected devices). To perform this operation:
1 Using the numeric keypad, press the ‘
1
’ button to
select the Disable/Enable Zone option.
2 The LCD displays the Zone option and prompts for a
zone number. Enter the zone number (one or two digits
entered via the numeric keypad). Press the ‘
5
’ to
confirm the zone number.
[U0] 1 : Test 2 : Disable/Enable 3 : Clock
4 : View Mode 5 : Commission
[U0 Disable/Enable] 1:Zone 2:Outputs
3:Day Mode 4:Delays
2
ACCESS TO MENUS RESTRICTED
Enter Level 2/3 Passcode: . . . . < : BackSp

Notifier ID50 SERIES Specifications

General

Brand	Notifier
Model	ID50 SERIES
Category	Fire Alarms
Language	English