Oki ML6300FB-SC User Manual

Paper handling > 19
L OADING CONTINUOUS FORMS
S ETTING UP CONTINUOUS FORMS
To avoid paper feeding problems, carry out the following:
1. Check your printer is on a surface approximately 75 cm above the floor.
2. Position the continuous forms supply directly below the printer, no more than 3 cm
left or right of the printer paper path.
3. Ensure the rear of the printer is close to and parallel with the edge of the surface
and at least 60 cm from any wall.
F EEDING CONTINUOUS FORMS
1. Ensure that the printer is turned ON.
2. Ensure the Paper Type Lever (1) is set to Continuous Forms.
3. Adjust the Paper Thickness Lever to suit the paper. See “Setting the Paper Thickness
lever” on page 22.
NOTE
If there is a cut sheet in the printer, eject it as described in “Ejecting cut sheet
paper” on page 18.
NOTE
If the Paper Thickness Lever setting does not match the paper being used,
paper feeding and printing may not work properly.
>=60 cm
75 cm
<=3 cm
1

Oki ML6300FB-SC Specifications

General

Color	No
Character pitch	10, 12, 15, 17, 17.1, 20 cpi
Maximum resolution	360 x 360 DPI
Maximum printing width (columns)	-
Fonts included	Courier, Roman, Swiss, Prestige, Gothic, Utility, Swiss Bold, Orator, OCR-A, OCR-B, HSD & Barcodes
Print technology	Dot matrix
Connectivity technology	Wired
Page description languages	Epson ESC/P2, IBM ProPrinter
Sound pressure level (printing)	58 dB
Print direction	Bi-directional
Mean time between failures (MTBF)	12000 h
Paper feed	Manual
Standard interfaces	Parallel, USB 2.0
Optional connectivity	Ethernet, Serial (RS-232)
Windows operating systems supported	Yes
Storage temperature (T-T)	-20 - 60 °C
Operating temperature (T-T)	5 - 40 °C
Storage relative humidity (H-H)	0 - 95 %
Operating relative humidity (H-H)	30 - 85 %
AC input voltage	220-240 V
AC input frequency	50 - 60 Hz

Weight and Dimensions

Depth	255 mm
Width	425 mm
Height	210 mm