Operating instructions > 25
B
UTTON
SWITCHES
SWITCH STATUS FUNCTION
SEL On-line Sets the printer to off-line.
Off-line Sets the printer to on-line and disalarms the
printer.
SHIFT Used only in conjunction with one of the following
buttons: SEL, LF, FF/LOAD, PARK, TEAR described
below.
LF On-line Feeds paper by one line. Holding the button down
results in continuous line feeding.
Off-line Feeds paper by one line. Holding the button down
results in continuous line feeding.
FF/LOAD On-line and off-line
Continuous Forms
mode
Continuous form fed until first line of next page.
On-line and off-line
Cut sheet manual
mode
Ejects the cut sheet.
TEAR On-line
Continuous Forms
mode
Delivers the continuous form to the cut position. If
the button is pressed again or data is received, the
original form position is restored.
On-line
Cut sheet manual
mode
Ineffective.
Off-line Ineffective.
PARK Continuous Forms
mode
If the continuous form is in position, press to
retract the form to the Pin Tractors.
(If the sprocket holes of the last page of the form
disengage from the sprocket pins, do not attempt
to eject the paper as a paper jam may result.)
SHIFT+SEL Enters menu mode.
SHIFT+LF Microfeed (0.14 mm step) down
Hold this button combination down for continuous
feeding or ejecting of paper.
SHIFT+FF/LOAD Microfeed (0.14 mm step) up
Hold this button combination down for continuous
feeding or ejecting of paper.
SHIFT+PARK On-line Ineffective.
Off-line Saves the set paper start position (first line print
position).
SHIFT+TEAR On-line Quieter print mode
Each press of the button pair progresses the printer
through Quieter print mode > High multipart print
mode > Normal print mode.
Off-line Ineffective.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
