Information
8
150
EN
Shooting tips and information
The camera does not turn on even when a battery is loaded
The battery is not fully charged
• Charge the battery with the charger.
The battery is temporarily unable to function because of the cold
• Battery performance drops at low temperatures. Remove the battery and warm it by
putting it in your pocket for a while.
No picture is taken when the shutter button is pressed
The camera has turned o automatically
• The camera automatically enters sleep mode to reduce the drain on the battery if no
operations are performed for a set period of time. g [Sleep] (P. 119)
Press the shutter button halfway to exit the sleep mode.
The camera will turn o automatically if no operations are performed for an additional
4 hours.
The ash is charging
• On the monitor, the # mark blinks when charging is in progress. Wait for the blinking to
stop, then press the shutter button.
Unable to focus
• The camera cannot focus on subjects that are too close to the camera or that are not
suited to autofocus (the AF conrmation mark will blink in the monitor). Increase the
distance to the subject or focus on a high contrast object at the same distance from the
camera as your main subject, compose the shot, and shoot.
Subjects that are dicult to focus on
It may be dicult to focus with auto focus in the following situations.
Subject with low
contrast
Excessively bright
light in center of frame
Subject containing
no vertical lines
AF conrmation
mark is blinking.
These subjects
are not focused.
Subjects at dierent
distances
Fast-moving subject Subject not inside
AF area
AF conrmation
mark lights up but
the subject is not
focused.