Troubleshooting
9
135
EN
Monitor indication Possible cause Corrective action
h
(blinks)
The current log has not been
saved to the card.
Insert the card correctly and save
the log to the card.
The current log cannot be saved
to the card.
• Each card can store up to 199
log fi les.
Copy log fi les to a computer and
delete them from the card.
There is a problem with the card. Insert a new card.
Writing to the card is prohibited.
The card write-protect switch is set
to the “LOCK” side. Release the
switch. (P. 15)
There is no space in the card
and print reservation or new
images cannot be recorded.
Replace the card or erase
unwanted pictures.
Before erasing, download
important images to a PC.
g
(steady)
The area of camera memory
used for temporary storage of
the log fi le is full.
Insert a card or confi rm that the
current card is correctly inserted
and transfer to log fi le to the card.
The battery is exhausted. Charge the battery.
The camera is connected to a
television or other device via an
HDMI cable.
Disconnect the HDMI cable.
Wireless data transfer is in
progress.
End transfer.
The USB-AC adapter is being
used to supply power to the
camera from an electrical outlet
while the battery is removed.
Insert the battery and unplug the
USB-AC adapter from the outlet.
The clock is not set.
Set the clock and select a time
zone.
g
(red)
GPS malfunction.
Turn the camera off and then on
again; if the message does not
clear from the display, contact an
OLYMPUS service representative.
To Next Page
Loading...
Need help?
General
