Omni Cresco User Manual

START (LED)
If lit, it indicates that the machine is performing
a wrapping cycle
or the that the machine is
waiting for the START to begin a Play Back
cycle.
If flashing, it i
ndicates that the machine is on
pause waiting for the Start to restart the
paused cycle.
ST
OP
When the machine is in AUTOMATIC mode, if
pressed, the button stops the wrapping cycle,
even if it has not finished yet (pause).
When the machine is in progra
mming mode
(RECORD), if pressed, the button memorizes
the machine stop in the cycle
that is being
saved.
ST
OP (LED)
When the machine I in AUTOMATIC mode, if
the STOP button is pressed, the led flashes
together with the START led.
When the machine is in
programming mode
(RECORD), it has different configurations
depending on the operating process (see Play
Back section for further informations)
RESET
When pressed, it reinitialises the machine
during turning on and after an emergency
stop.
During loading and save phases this button
cancels the operations performed.
R
ESET (LED)
If lit, it indicates that a RESET cycle is being
performed.
If flashing, it signals the need to perform a
reset cycle.
SAVE
Press SAVE to save a data set or a
customized cy
cle (“play back” cycle) and
associate an identification.
LOAD
Press LOAD to recall and load a data set or a
customized cycle (“play back” cycle).
The load menu begins with custom cycles
(Pr1-Pr9) and continues with Play Back cycles
(rEc1-rEc9).
CRESCO UCP REV10 9

Omni Cresco Specifications

General

Brand	Omni
Model	Cresco
Category	Stretch Wrapping Systems
Language	English