8-81
8 Pulse Outputs
CJ2M CPU Unit Pulse I/O Module User’s Manual
8-9 Application Example
8
8-9-4 Feeding Wrapping Material: Interrupt
Feeding
z PLC Setup
Note The interrupt input setting is read from the PLC Setup when the power supply is turned ON.
z DM Area Settings
• Speed Control Settings to Feed Wrapping Material to Initial Position and Positioning Control Set-
tings for Wrapping Material
z Cyclic Task Program (Executed at Startup)
Preparations
Setting
Enable using input IN00 as interrupt input.
Setting Word Data
Acceleration rate: 500 pps/4 ms D10 #01F4
Deceleration rate: 500 pps/4 ms D11 #01F4
Target frequency: 10,000 pps D12 #2710
D13 #0000
Number of output pulses: 5,000
pulses
D14 #1388
D15 #0000
Ladder Program
2960.04 W0.01
W0.00
A280.03
2960.01
W0.00
W0.01
@IFEED
#0000
#0100
D10
@INI
#0000
#0003
0
Feeding Material with Speed Control
Start feeding
material
Material
being fed
Packaging
material
positioning
completed
Pulse output completed
Immediate stop
Immediate stop switch
Material being fed
Packaging material
positioning completed
To Next Page
Loading...
Need help?
General
