28
CJ2M CPU Unit Pulse I/O Module User’s Manual
This product conforms to the following shipbuilding standards. Applicability to the shipbuilding stan-
dards is based on certain usage conditions. It may not be possible to use the product in some loca-
tions. Contact your OMRON representative before attempting to use a PLC on a ship.
z Usage Conditions for Applications Other Than on the Bridge or Deck
• The PLC must be installed in a control panel.
• Gaps in the door to the control panel must be completely filled or covered with gaskets or other
material.
z Usage Conditions for Bridge and Deck (Certified Only by NK)
• The PLC must be installed in a control panel.
• Gaps in the door to the control panel must be completely filled or covered with gaskets or other
material.
• The following noise filter must be connected to the power supply line.
Noise Filter
This product complies with applicable UL and CSA standards. The following application conditions were
specified for compliance. Refer to Precaution for Compliance with Standards and CSA Standards pro-
vided with the product in advance.
z The temperature inside the control panel must be 50°C or less.
z The following Connector-Terminal Block Conversion Unit and Connecting
Cable must be used to wire I/O.
• Connector-Terminal Block Conversion Unit: XW2B-40G4
• Connecting Cable: XW2Z-@@@K@
z A power supply that complies with UL Class 2 must be used for the output
power supply.
Conformance to Shipbuilding Standards
Usage Conditions for NK and LR Shipbuilding Standards
Manufacturer Cosel Co., Ltd.
Model TAH-06-683
Conformance to UL and CSA Standards
Application Conditions for the CJ2M-MD21@
To Next Page
Loading...
Need help?
General
