4-2SectionProgramming Console Operations
100
SHIFT
B
1
<MONITOR>
The buzzer will not sound
when “BZ” is not displayed.
3. Press the SHIFT and then the 1 Key again to turn the buzzer back ON.
SHIFT
B
1
<MONITOR> BZ
4-2-7 Assigning Expansion Instruction Function Codes
This operation is used to display or change the expansion instructions assigned
to expansion instruction function codes. The assignments can be displayed in
any mode, but can be changed in PROGRAM mode only.
Operation RUN MONITOR PROGRAM
Read assignment OK OK OK
Change assignment No No OK
Assign expansion instruction function codes before inputting the program.
The CPM2A will not operate properly if expansion instructions aren’t as-
signed correctly. An expansion instruction can be assigned to one function
code only.
The PC Setup must be set for user-defined expansion instruction assign-
ments. Set bits 8 to 11 of DM 6602 to 1 and turn the PC’s power off and then
on again to enable the new setting.
1, 2, 3... 1. Press the CLR Key to bring up the initial display.
2. Press the EXT Key to display the assignment for the first function code (17).
EXT
INST TBL READ
FUN017:ASFT
3. Press the Up and Down Arrow Keys to scroll through the expansion instruc-
tion function codes.
↓
INST TBL READ
FUN018:FUN
4. Press the CHG Key to assign a different expansion instruction to the selec-
ted function code.
CHG
INST TBL CHG?
FUN018:FUN ~????
5. Press the Up and Down Arrow Keys to scroll through the expansion instruc-
tions that can be assigned to the selected function code.
↓
INST TBL CHG?
FUN018:FUN ~HEX
6. Press the WRITE Key to assign the displayed instruction to the function
code.
WRITE
INST TBL READ
FUN018:HEX
4-2-8 Setting and Reading a Program Memory Address and Monitoring
I/O Bit Status
This operation is used to display the specified program memory address and is
possible in any mode. In the RUN or MONITOR mode, the I/O bit status of bits in
the program will be displayed.
RUN MONITOR PROGRAM
OK OK OK
To Next Page
Loading...
Need help?
General
