1-19
Commands and Responses (CompoWay/F Communications) Section 1-9
CompoWay/F
Communications
Response
Response codes: The above indicates a normal end. For the response codes,
see 1-7 Operation Commands (CompoWay/F Communications) (page 1-11).
1-9-13 Zero Execute/Cancel
Command
This command is used to execute/cancel the forced zero and tare zero func-
tions. The results of the command will depend on the status of the tare zero
setting, as shown below.
This command can be used only in setting area 0. An operation error will
occur in the following situations.
• When there is no-measurement status, there is an input error, or a mea-
surement is outside the display range (but zero cancel is possible.)
• When a RESET or HOLD input is ON
• When the command is used in setting area 1
Response
Response codes: The above indicates a normal end. For the response codes,
see 1-7 Operation Commands (CompoWay/F Communications) (page 1-11).
1-9-14 Software Reset
Command
A software reset causes the same operation as turning the power off and on.
This command can be used in both setting area 0 and setting area 1.
To use this command, “Write via communications” must be enabled using the
“Write via communications” operation command.
Response (No response)
A response is not returned to this operation command.
"30" "05" "0000"
Response code
SRCMRC
Related information Description
“00” Zero cancel
“01” Zero execute
Tare
zero
Commands executed in order left to right.
Zero execute Zero execute Zero cancel Zero cancel
OFF Forced zero ON Forced zero ON Forced zero OFF Forced zero OFF
ON Forced zero ON Tare zero ON Tare zero OFF Forced zero OFF
"30" "05"
SRC
"03"
Command
code
Related
information
MRC
"30" "05" "0000"
Response code
SRCMRC
"30" "05"
SRC
"06" "00"
Command
code
Related
information
MRC
To Next Page
Loading...
Need help?
General
