3-4
3-2 Outline of Operation
H Selecting Indicators
Whenever
the Mode Key is pressed, an indicator is lit in sequence begin
-
ning with the FREF indicator. The data display indicates the item corre-
sponding to the indicator selected.
The
FOUT or
IOUT indicator will be lit by turning the Inverter on again if the
Inverter
is turned of
f while the FOUT or IOUT indicator is lit. The FREF indi
-
cator
will be lit by turning the Inverter on again if the Inverter is turned of
f
while an indicator other than the FOUR or IOUT indicator is lit.
Power On
FREF (Frequency Reference)
Monitors and sets the frequency reference.
FOUT (Output Frequency)
Monitors the output frequency.
Note This
indicator will be lit by turning the Inverter on
again
if the Inverter is turned off while this indicator is lit.
IOUT (Output Current)
Monitors the output current.
Note This
indicator will be lit by turning the Inverter on again
if the Inverter is turned off while this indicator is lit.
MNTR (Multi-function Monitor)
Monitors the values set in U01 through U10.
F/R (Forward/Reverse Rotation)
Selects the direction of rotation.
LO/RE (Local/Remote)
Selects the operation of the Inverter through the Digital
Operator or according to the parameters.
PRGM (Parameter Setting)
Monitors or sets the values in n01 through n79.
The FREF indicator is lit again.
Preparing for Operation and Monitoring Chapter
3
To Next Page
Loading...
Need help?
General