Omron SYSMAC FH Series User Manual

WWW.NNC.IR
Setting the Operation Mode
280
Vision System FH/FZ5 Series
User’s Manual (Z340)
6 In the Main Window for line 1, select [Non-stop data transfer] from the [Function] menu.
The changes to the settings for line 1 are saved as the settings for line 0 without affecting the
measurement.
7 Click the [Switch Screen] button to display the Main Window for line 0.
The following processing items are supported in Non-Stop Adjustment Mode:
• When you execute [Non-stop data transfer], the results in the Trend Monitor and Expression processing units are
cleared.
• If you use an external command to switch scenes or scene groups, or change the settings of processing units while the
Controller is in RUN mode, the results of those changes will not be applied when you change to line 1 (Adjustment Mode)
in the Main Window.
• If you use the Non-stop Adjustment Mode after you change the scene group while the Controller is in RUN mode, you
may overwrite the scene group data unintentionally.
• The only communications commands that are accepted during a non-stop data transfer are the measurement (parallel,
non-procedure, or PLC Link) and continuous measurement (parallel only) commands.
• The larger the size of the scene group file, the longer the non-stop data transfer will take.
• The communications settings cannot be changed in Non-stop Adjustment Mode.
• Do not register a new Camera Image Input processing unit in the Non-stop Adjustment Mode Window.
• If there is not enough external memory when you are about to do a non-stop data transfer, the transfer may not start. Set
the destination for image logging to a destination that does not use external memory.
• Do not change the image mode for Non-stop Adjustment Mode.
• If you use image logging in Non-stop Adjustment Mode, the non-stop data transfer may become unavailable. To avoid
this, set the trigger frequency so that it is longer than the logging time.
• Do not change the settings for image input processing items and do not change Camera parameters in the system
settings in Non-stop Adjustment Mode.
OK:Supported processing item, RST: Processing item with restricted support, ---:Unsupported processing item
Processing item Support Processing item Support Processing item
Camera Image Input --- Glue Bead Inspection OK Statistics ---
Camera Image Input FH --- Position Compensation OK Reference Calib Data OK
Camera Image Input HDR --- Filtering OK Position Data Calculation OK
Camera Image Input HDR Lite --- Back Ground Suppression OK Stage Data OK
Camera Switching OK Brightness Correct Filter OK Robot Data OK
Measurement Image
Switching
OK Color Gray Filter OK
Vision Master Calibration ---
Search OK Extract Color Filter OK
PLC Master Calibration ---
Flexible Search OK Anti-Color Shading OK Convert Position Data OK
Sensitive Search OK Stripes Removal Filter II OK Movement Single Position OK
ECM Search OK Polar Transformation OK Movement Multi Points OK
EC Circle Search OK Trapezoidal Correction OK Detection Point OK
Ec Corner OK Machine Simulator OK Camera Calibration OK
Ec Cross OK Image Subtraction RST(*1) Data Save OK
Shape Search II OK Advanced Filter OK Conditional Branch OK
Classification OK Panorama OK End OK
Edge Position OK Calculation OK DI Branch ---
Edge Pitch OK Line Regression OK Control Flow Normal RST(*3)
Scan Edge Position OK Circle Regression OK Control Flow PLC Link RST(*3)
IMPORTANT

Omron SYSMAC FH Series Specifications

General

Brand	Omron
Model	SYSMAC FH Series
Category	Industrial Equipment
Language	English