Omron SYSMAC FH Series User Manual

WWW.NNC.IR
Remotely Operating the Controller (Remote Operation)
159
4
Using Tools
Vision System FH/FZ5 Series
User’s Manual (Z340)
Operation Environment Condition
The following is required on both the Controller and on the remote operation PC to start the remote operation.
• Controller side = Set up a server to achieve the remote operation.
• Remote operation PC side = Prepare a communications environment and a GUI environment
for remote operation.
Install FZ_FH Remote Operation Tool on the remote operation PC.
Environment Settings on the Remote Operation PC
The recommended operating conditions for the remote operation PC are as follows:
To use the remote operation software, Microsoft .NET Frameworks 3.5 must be installed.
This CD-ROM contains the Microsoft .NET Frameworks 3.5 installer. Please use as required.
Set the network
Specify the network settings on both the Controller and the remote operation PC.
In the Communications Module, specify the module by serial (Ethernet) and enter the IP address.
1 Set the Communications Module.
In the Main Window, select [System settings]
− [Startup] − [Startup settings] from the [Tool]
menu, and then select [ON] for Remote
Operation in the Communications Module
Area.
Make sure that the software installed on the remote operation PC is of the same version as that on the Controller.
CPU Intel Pentium Processor (SSE2 or higher)
OS
Windows 7 Professional (32/64bit) or Enterprise (32/64bit) or Ultimate (32/64bit),
Windows 8 Pro (32/64bit) or Enterprise (32/64bit),
Windows 8.1 Pro (32/64bit) or Enterprise (32/64bit)
Memory 2 GB (3 GB or higher recommended)
Hard disk free capacity 2 GB or higher
Display window
Resolution 1,024 x 768 dots or higher
Display color True Color (32 bits)
Network 10Base-T compatible network (100Base-TX recommended)
Optical drive CD/DVD drive
For remote operation, use the following ports on the PC to communicate with the Sensor Controller.
9900 + Line number (e.g., port 9900 for line 0)
9910 + Line number (e.g., port 9910 for line 0)
9920 + Line number (e.g., port 9920 for line 0)
Line Numbers: FH: 0 to 7, FZ5: 0 or 1
If you cannot use these ports due to security settings of your PC or the domain security policies, you will not be able to
perform remote operation.
Either change the settings of the PC firewall or security software or contact your domain security administrator.
IMPORTANT
IMPORTANT

Omron SYSMAC FH Series Specifications

General

Brand	Omron
Model	SYSMAC FH Series
Category	Industrial Equipment
Language	English