26
Programming remote controller codes
Universal Programmable Remote Controller RC-374M
If you are using another manufacturer’s product that has a remote controller, you can memorize that component’s codes into the RC-374M.
NOTE:
•
The commands of Onkyo cassette tape decks and the CD player are already stored at the TAPE and CD positions of the remote controller.
•
This remote controller uses infrared rays. Most remote controller codes can be memorized using the infrared system; however, depending
on the degree to which the system differs, there may be some rare occasions when memorization is not possible.
Device commands
Symbol VDP VCR TV
POWER POWER POWER
PLAY PLAY –
STOP STOP –
– – CHANNEL UP, DOWN
– FAST REWIND –
– FAST FORWARD –
– – VOLUME UP/DOWN
– Rec/Pause –
TV/VCR
– – TV/VCR switching
1. SENDING/
LEARNED
indicator
2. A/B-SUB ROOM/
LEARN selector
switch
3. PROGRAMMABLE
AREA
POWER
SLEEP
DVD
VIDEO-1
VIDEO-2
TAPE-1 TUNER PHONO C D
SOURCE SELECTOR
GROUP
DIMMER
TAPE-2
POWER
POWER
VOLUME
C H
TV/VCR
TEST
TONE
SENDING/
LEARNED
LEARN
SUBROOM
PRESET
AB
PROGRAMMABLE AREA TV/VIDEO
TUNER
MULTI-CH
INPUT
SUR
MODE
1. SENDING/LEARNED indicator
This indicator acts as a guide when commands are programmed
into or sent by the remote controller. It also warns the user when
an error is made or battery power is low.
2. A/B-SUB ROOM/LEARN selector switch
A: Select MAIN to operate the system from the main room,
such as when playing a sound source using a Surround mode.
B-SUBROOM: Select SUB to operate the Onkyo Multi-Room
Remote System, the A-DS650, and other brands’ components
from the sub-room.
LEARN: Select LEARN to store another remote controller’s
signal code.
3. Programmable button area
See the table below.
Displays and switches
POWER
C H
VOLUME
To Next Page
Loading...
Need help?
General
