78
Zone 2
—Continued
If you’ve connected your Zone 2 speakers to the AV
receiver, as explained in “Connecting Your Zone 2
Speakers Directly to the AV receiver” on page 77, you
must set the Powered Zone 2 setting to Act (Activated).
Notes:
• When Act is selected and Zone 2 turned on, the Zone 2
speakers connected to the ZONE 2 L/R speaker termi-
nals output sound, but the surround back speakers con-
nected to the SURR BACK L/R speaker terminals do
not. When Act is selected and Zone 2 turned off, the
surround back speakers output sound as normal.
•Powered Zone 2 cannot be used if Sp Type is set to Bi-
Amp.
• This procedure can also be performed on the AV
receiver by using its [SETUP], [ENTER], and arrow
buttons.
Powered Zone 2 Setting
1
Press the [RECEIVER] REMOTE
MODE button, followed by the
[SETUP] button.
2
Use the Up and Down [ ]/[ ]
buttons to select “Hardware-
Setup,” and then press [ENTER].
If you have a TX-SR506, proceed to
step 4.
SETUP
RECEIVER
ENTER
3
(TX-SR576 only)
Use the Up and Down [ ]/[ ]
buttons to select “7-2.Zone2,”
and then press [ENTER].
4
Use the Up and Down [ ]/[ ]
buttons to select “PwrdZ2.”.
5
Use the Left and Right [ ]/[ ]
buttons to select:
Not Act:
ZONE 2 SPEAKERS L/R
speaker terminals not acti-
vated (Powered Zone 2 dis-
abled).
Act:
ZONE 2 SPEAKERS L/R
speaker terminals activated
(Powered Zone 2 enabled).
6
Press the [SETUP] button.
Setup closes.
TX-SR506En.book Page 78 Friday, February 29, 2008 5:31 PM
To Next Page
Loading...
Need help?
General
Weight and Dimensions
