2. Lower the leveling feet to the floor as shown in Figure 3-3 using the SW 12 mm
wrench. When lowered correctly, the four leveling feet should support the full
weight of the Exalogic machine.
Figure 3-3 Securing Exalogic Machine Using the Leveling Feet
3.2.6.4 Stabilize the Exalogic Machine with Mounting Brackets
The rack can be permanently mounted to the installation site floor using the same
mounting brackets that secured the rack to the shipping pallet. The rack is secured to
the pallet with four mounting brackets. Use the front and rear brackets to stabilize the
rack to the installation floor. Prepare the installation site by drilling four holes into the
floor. Before permanently stabilizing the Exalogic machine with the mounting
brackets, pre-drill the mounting holes. Figure 3-4 shows the location and dimensions
of the mounting brackets.
Prepare to Install an Exalogic Machine
3-8 Oracle Exalogic Elastic Cloud Machine Owner's Guide
To Next Page
Loading...
Need help?
General
