28
Manual Scan
1
Press DIGITAL MENU, the menu will appear on the screen.
Press
or to select Installation option.
Press
or to select ‘Manual Scan’ from the sub menu
tab, then press ENTER.
Manual Scan
Auto Scan
Carrier Setup
noitallatsnIunem niaM
AC
B
2
You can choose the carrier number from the Channel list by
using
or and the corresponding frequency set for the
carrier will be set for tuning.
Manual Scan
Channel list
Ch-21
Frequency (kHz
)
474000
Navigate
Enter Exit
0..9
3
Otherwise you can also directly enter the frequency value to
start the tuning.
Manual Scan
Ch-21
Frequency (kH
z)
474000
Enter Exit
0..9
Navigate
Channel list
4
After setting the carrier, press ENTER to start the scanning.
During the scan process, the list of services (TV/Radio)
collected for the carrier will be listed.
On completion, ‘Scan completed’ message will be shown.
Information
Scan Completed
5
Then the confirmation banner will be displayed.
Press
or to select ‘Yes’ or ‘No’, then press ENTER
(the selected option is shown in blue).
6
Press EXIT to return to the normal screen.
With the Manual Scan option, you
can tune one carrier at a time, by
entering the carrier parameters
manually.
Notes:
If on the ‘AUTO INSTALLATION
(COUNTRY)’ screen ‘FINLAND’ is
selected, ‘Frequency (kHz)’ cannot
be used.
When the Country is set
to FINLAND in the ‘AUTO
INSTALLATION (COUNTRY)’
If there is a Channel List in the data
after AUTO Scan or MANUAL Scan,
Channel Type Selection Menu will
be displayed and available to set
Channel List Type.
Select the Channel List Type by
pressing
/ and press ENTER.
•
•
32W0146A_ENG.indd 2832W0146A_ENG.indd 28 6/6/07 10:54:01 AM6/6/07 10:54:01 AM
To Next Page
Loading...
Need help?
General
