Panasonic KX-NS500 User Manual

3.1.3 Customising the Buttons
You can customise the flexible buttons and/or programmable feature (PF) buttons on PTs, Add-on Key
Modules, and PSs. They can then be used to make or receive outside calls or as feature buttons.
• To enter programming mode when using a PS, refer to the documentation for your PS.
• The buttons in the table below can only be set on certain flexible buttons, as follows:
– Flexible buttons on PTs/Add-on Key Modules/PSs: all buttons can be set.
– Flexible buttons
on DSS Consoles: all buttons except CTI and Primary Directory Number
(PDN) buttons can be set.
– Programmable feature (PF) buttons: only the One-touch Dialling button can be set.
• For KX-UT series SIP phone users and S-PS users: You cannot customise the flexible
buttons with the following method from your phone. You can customise the flexible buttons
using Web Maintenance Console. For details, refer to "Customising the Flexible Buttons".
• For KX-NT511 users:
Since there is no PROGRAM button on a KX-NT511, press and hold flexible button 1, 2, or
3 instead.
Press PROGRAM
or PAUSE.
Press PROGRAM
or PAUSE.
Press desired
flexible button.
To exit To programme To enter the programming mode
Follow
programming input.
To continue
programming
input
Press ENTER
or STORE.
OR
OR
PROG.
PAUSE
OR
PROG.
PAUSE
Button Programming Input
Loop-CO (L-CO)
Group-CO (G-CO)
#
+ Outside line group no. (2 digits)
Single-CO (S-CO)
0
+ Outside line no. (3 digits)
Direct Station Selection
(DSS)
1
+ Extension no.
*12
One-touch Dialling
*1
2
*2
+ Desired no. (max. 32 digits)
Incoming Call Distribution
Group (ICD Group)
3
0
+ Incoming call distribution group extension no. (+
#
+ delayed ringing time [0–7])
*3
Message
4
0
Message for Another
Extension
4
0
+ Extension no./Incoming call distribution group
extension no.
Call Forwarding (FWD)/Do
Not Disturb (DND)—Both
calls
4
1
322 User Manual
3.1.3 Customising the Buttons

Panasonic KX-NS500 Specifications

General

Brand	Panasonic
Model	KX-NS500
Category	PBX
Language	English