Name: PEUGEOT SpeedFight 3
Brand: PEUGEOT
Rating: 4 (1 reviews)

To Next Page

To Previous Page

SERVICE OPERATIONS

Reproduction or translation, even partial, is forbidden without the written consent of Peugeot Motocycles

Removal of the spark plug

- Remove the rear storage compartment.

See: Procedure 1 page 19.

- Disconnect the suppressor (1).

- Remove the spark plug using tool

P/N 766062.

Essential precautions: When re-

installing, srew in the spark plug (a

few turns) by hand.

- Tighten the spark plug.

Tightening torque: 12 Nm.

Replacing the air filter.

- Remove the air filter cover (7 bolts) and its

seal.

- Remove the air filter (1).

- Clean inside the air filter box.

- Fit a new air filter.

- Fit the gasket (2).

- Install the air filter cover.

Check the condition of the seals

and make sure they are properly

positioned.

Questions and Answers:

Need help?

Do you have a question about the PEUGEOT SpeedFight 3 and is the answer not in the manual?

PEUGEOT SpeedFight 3 Specifications

General