Name: PEUGEOT SpeedFight 3
Brand: PEUGEOT
Rating: 4 (1 reviews)

To Next Page

To Previous Page

POWER UNIT

Reproduction or translation, even partial, is forbidden without the written consent of Peugeot Motocycles

POWER UNIT

Removal of the power unit

Note: To remove the cylinder head, remove

the power propulsion unit.

For removal of the cylinder head, cylinder

and piston, see the workshop

manual: 2-valve, 50cc 4-stroke

engine.

- Remove the storage compartment. See:

Procedure 1. page 19.

- Remove the lower fairing by sliding it

towards the rear of the vehicle (1 screw).

- Disconnect:

• The magneto (1).

• The starter motor (1).

• The choke (1).

• The suppressor (2).

• The carburettor heater (3).

- Disconnect:

• The throttle control (4).

• The fuel inlet pipe (5).

• The vacuum pressure hose (6) (Pulsair).

• The vacuum pressure hose (7) (Fuel pump).

• The pulsair reed valve hose (8).

• The rear brake control cable.

Questions and Answers:

Need help?

Do you have a question about the PEUGEOT SpeedFight 3 and is the answer not in the manual?

PEUGEOT SpeedFight 3 Specifications

General