Preparation
9 Preparation
All regulations and instructions in this Instruction Manual are to be observed!
Special attention is to be paid to the safety regulations!
All preparation work is only to be carried out by appropriately trained
personnel. Before all preparation work, the machine is to be separated from
the electricity supply by removing the plug from the mains or switching off
the On/Off switch!
9.01 Inserting the needle
Turn the machine off!
Use only system 134 needles.
● Raise roller presser 1.
● Swing the eye guard upwards.
● Pull roller presser 1 downwards slightly
and swing it out to the left.
● Loosen screw 2 and insert needle 3
until you feel it stop. The long groove
must be facing the left.
● Tighten screw 2 and swing the roller
presser back.
Fig. 9 - 01
3
2
1
The selection of the correct needle depends on the model of the machine and
the material and threads being sewn (see chapter 3.02 Needle and thread).
9 - 1
To Next Page
Loading...
Need help?
General
