Sewing
Fig. 10 - 03
Explanation of the functions in the display:
Program interruption
This function interrupts the sewing of the seam program.
See chapter 10.05 Program interruption.
Needle up
By activating this function, the machine runs until the needle is at its top position when
stopping (without thread trimming).
Program selection
This function opens a direct menu for selecting the desired seam program.
Needle position
When this function is active, the machine positions the needle at its top position when
stopping. When this function is deactivated, the needle stops at its lowest position.
Roller presser up after stop
When this function is active, the roller presser is raised when the machine is stopped.
Roller presser down after trimming
When this function is active, the roller presser is lowered after the trimming process.
Thread trimming
When this function is active, the thread is cut when the pedal is pressed backwards.
Start bartack
- When pressed once the single start-bartack is switched on.
- When pressed again a double start-bartack is switched on.
- Activating a third time switches the start bartack back off again.
End bartack
- When pressed once the single end-bartack is switched on.
- When pressed again a double end-bartack is switched on.
- Activating a third time switches the end bartack back off again.
For information on altering fixed programs see chapter 11.11.01
Altering fixed programs.
1 2
3
4 5 6 7 9 0
Enter
8
Esc
Clear
10 - 3
To Next Page
Loading...
Need help?
General
