When a 3D programme is shown on screen, press
on the 3D
glasses and put them on. The glasses need some seconds to
adjust to the 3D signal from the 3D transmitter on the TV. At
first use, this may take up to 15 seconds.
Battery level
You can check the battery level when you switch on the 3D
glasses.
If the LED light blinks green, you can use the glasses for 4
hours or more.
If the LED light blinks orange, you can use the glasses for
at least 2 hours but less than 4.
If the LED light blinks red, the battery is almost empty
and less than 2 hours of 3D watching remain.
Switch off
To switch off the 3D glasses, press
. The LED light blinks red 4
times. When the 3D glasses do not receive 3D signals for 2
minutes, the glasses switch off automatically.
3D transmitter
3D transmitter
Make sure the receiver lens in the centre of the glasses can
receive the 3D signals. Also, clear objects away from the 3D
transmitter on the TV.
1. 3D transmitter on the TV
2. 3D receiver on the 3D glasses
Two-player gaming
Two-player gaming
You can use these glasses to play two-player games. Two players
can watch the same TV but see two different screens to play a
game.
To switch the glasses to watch the Player 1 or Player 2 screen,
switch on the glasses and then press the Player 1/2 key.
If the LED light is orange and lits continuously for 2
seconds, the glasses are set for player 1.
If the LED light is orange and blinks, the glasses are set
for player 2.
For more information, press
Keywords and look up Two-
player gaming.
Replacing the batteries
To replace the battery of the 3D glasses PTA508, unscrew the
small battery lid and replace the battery: type CR2032 (3V).
Make sure the + side of the battery is visible. Replace the lid and
fix it with the screw.
To replace the battery of the 3D glasses PTA509, PTA51, press
the small knob on the battery lid and slide the lid up to open.
Replace the battery: type CR2032 (3V). Make sure the + side of
the battery is visible. Replace the lid and slide it down until it
clicks.
Warning
Danger of explosion if the battery is incorrectly replaced.
Replace only with the same or equivalent type.
For Passive 3D sets
When a 3D programme is shown on screen, simply put on the
3D glasses to watch the programme in 3D.
Recommended viewing height
For best picture quality, when watching passive 3D, your eyes
should be level with the centre of the screen.
12.4
Care of the 3D glasses
Do not use cleaning chemicals containing alcohol,
solvent, surfactant, or wax, benzene, thinner, mosquito
repellent or lubricant. Using these chemicals can cause
discoloration or cracks.
Do not expose the 3D glasses to direct sunlight, heat,
fire or water. This may result in a product malfunction or
fire.
Do not drop, bend or apply force to the lenses of the
3D glasses.
Use a clean soft cloth (microfiber or cotton flannel) to
clean the lenses to avoid scratching them. Never spray
cleaner directly onto the 3D glasses. This may damage
the electronics (for Active 3D glasses).
Do not use cleaning chemicals containing alcohol,
solvent, surfactant, or wax, benzene, thinner, mosquito
repellent or lubricant. Using these chemicals can cause
discoloration or cracks.
Do not expose the 3D glasses to direct sunlight, heat,
fire or water. This may result in a product malfunction or
fire.
Do not drop, bend or apply force to the lenses of the
3D glasses.
12.5
Watch 3D
To experience the best 3D effect while you watch 3D
programs:
Sit at a distance that is at least three times the width (w)
37
To Next Page
Loading...
Need help?
General
Weight and Dimensions
