Customizing SoundStructure Designs
5 - 19
For more information on the processing available for the Clink2 channels, see
Chapter 6 Connecting To Conference Link devices.
Input Channel Controls
This section discusses the input controls in the order that they appear on the
channels page. The input channel settings are shown in the following figure in
both a collapsed view and with the different areas expanded to show the addi-
tional controls.
Any setting for a virtual channel can also be set by adjusting the setting on a
virtual channel group. By using virtual channel groups, the system can be
setup very quickly because the parameters will propagate to all the underlying
virtual channels.
The input channel controls may be expanded to show less frequently used con-
trols such as phantom power, trim, delay compensation, and the selection of
the different ungated signal types. See Chapter 2 for more information about
the ungated/recording signal types and the signal processing that is available
Matrix
HDX Program
Audio In
Dynamics
Processing
Parametric
Equalization
Fader Delay
Mute
HDX
Video Call In
Dynamics
Processing
Parametric
Equalization
Fader Delay
Mute
HDX
PSTN In
HDX
UI Audio In
Inputs from
Polycom HDX
over CLINK2
To Next Page
Loading...
Need help?
General
