Polycom SoundStructure C8 User Manual

Design Guide for the Polycom SoundStructure C16, C12, C8, and SR12
8 - 30
ran “Power-On”
Partial Presets
Partial presets will generate command acknowledgements for all parameters
that are changed during the execution of the preset. The outputs of the system
are not muted during a partial preset unless the designer explicitly inserts
commands to mute the outputs of the system during the partial preset.
Once the full preset has finished running, a ‘ran’ command acknowledgment
is generated as shown next where “Partial Preset” would be replaced with the
name of the partial preset that was executed.
ran “Partial Preset”
Removing Presets
Presets may be removed from the system by left clicking on the preset and then
clicking Remove Preset.
If the power-on preset is removed and the system rebooted, the system will
boot into the current settings if they have been stored in the configuration file.
Full preset execution does not generate any command acknowledgements from the
SoundStructure system. If specific parameters are required after a preset has been
executed, the values for the parameters should be queried after a preset has
executed.
The outputs of the system are muted during the execution of a full preset. The
outputs are unmuted after the preset has executed. This muting does not affect the
state of the safety mute or any other mute parameter.

Polycom SoundStructure C8 Specifications

General

Brand	Polycom
Model	SoundStructure C8
Category	Conference System
Language	English