Integrating The Polycom Touch Control with SoundStructure Systems
11 - 7
address of the SoundStructure system, and the confirm that the Polycom
Touch Control has a valid IP address and that there is a network route to
the SoundStructure system and then press Connect again.
6. Once the system pairs successfully, the Polycom Touch Control will
display a successful pairing screen as shown in the following figure.
If the network connection is lost for any reason, the Polycom Touch
Control device automatically attempts to restore the connection.
If the connection is lost the Polycom Touch Control will show a banner
across the top of the screen that indicates the connection to the
SoundStructure has been temporarily lost as shown in the following
figure. If this message appears, then check that there is a valid network
To Next Page
Loading...
Need help?
General
