Related Topics
Video Calls on Polycom Trio Systems
Handling a Mixture of Audio and Video Calls
When you are in a call with a person who has a video-enabled phone or video conferencing system,
the participants' video displays on the connected monitor. For video calls with audio-only contacts, only
your video stream displays on the monitor, and an Audio icon
displays on the monitor with the
number of contacts on audio.
When you do not have a USB camera attached to the Polycom Trio Visual+, you can receive video, but
you cannot send video. Video always displays when a contact can send video and the system is
enabled to receive video.
Related Topics
Video Calls on Polycom Trio Systems
Camera Presets on Polycom Trio
You can store and modify camera presets on a Polycom Trio system with a connected Polycom
camera.
Presets aren’t supported with the Logitech Webcam C930e camera.
Camera presets are stored camera positions that you can create before or during a call. Presets
enable you to quickly point a camera at pre-defined locations in a room and persist until you change
them. The system uses preset 0 as the default camera position for all preset camera positions. This
default camera position is zoomed out, panned straight ahead with horizontal tilt.
If your system camera supports pan, tilt, and zoom movement, you can create up to 10 preset camera
positions for the near-end camera. Each preset stores the following information:
•
Camera number
•
Camera zoom level
•
Camera direction
•
Snapshot of the camera view
Related Topics
Video Calls on Polycom Trio Systems
Printed from Polycom, Inc. (http://documents.polycom.com) Page 53
To Next Page
Loading...
Need help?
General
