3–Installing Drivers
Windows Driver Software
18 BC0154503-00 C
Linux Driver Messages
To set the Linux driver message detail level, use one of the following commands:
ethtool -s <interface> msglvl <value>
modprobe qede debug=<value>
The <value> represents bits 0–15, which are standard Linux networking values,
and bits 16 and greater are driver specific.
Statistics
Detailed statistics and configuration information can be viewed using the ethtool
utility. See the ethtool man page for more information. Also see Step 7 on
“Verifying the RoCE Configuration on Linux” on page 65 for more information.
Windows Driver Software
This section describes the following topics:
Installing the Windows Drivers
Removing the Windows Drivers
Managing Adapter Properties
Setting Power Management Options
Installing the Windows Drivers
You can run a software or driver Dell update package in two ways:
Running the Dell Update Package in the GUI
Installation Options
To Next Page
Loading...
Need help?
General
