Qlogic QL45212 User Manual

6–Configuring RoCE
Preparing the Adapter
50 BC0154503-00 C
Preparing the Adapter
The following steps describe how to enable DCBX, and specify the RoCE priority
using the HII management application. For information about the HII application,
see Chapter 5, Preboot Adapter Configuration.
1. In the Main Configuration Page, select Data Center Bridging (DCB)
Settings, and then click Finish.
2. In the Data Center Bridging (DCB) Settings window, click the DCBX
Protocol drop-down. The QL45212 Adapter supports both CEE and IEEE
protocols. This value should match the corresponding value on the DCB
switch. In this example, select CEE.
3. Click the RoCE Priority field, and type a priority value. This value should
match the corresponding value on the DCB switch. In this example, type 5.
4. Click Back.
5. When prompted, click Yes to save the changes. Changes will not take effect
unit after a system reset.

Qlogic QL45212 Specifications

General

Brand	Qlogic
Model	QL45212
Category	Adapter
Language	English