Qlogic QL45212 User Manual

4–Upgrading Firmware
Updating Dell DUP Using .BIN File
37 BC0154503-00 C
Updating Dell DUP Using .BIN File
Use the following procedure to update the Dell DUP using the .bin file:
1. Copy the Network_Firmware_NJCX1_LN_X.Y.Z.BIN file to SUT.
2. Change the file type into an executable file:
chmod 777 Network_Firmware_NJCX1_LN_X.Y.Z.BIN
3. Run ./Network_Firmware_NJCX1_LN_X.Y.Z.BIN to start the update
process.
4. Reboot the system after the firmware update.
The following is an example output from SUT during the DUP update.
./Network_Firmware_NJCX1_LN_08.07.26.BIN
Collecting inventory...
Running validation...
BCM57810 10 Gigabit Ethernet rev 10 (p2p1)
The version of this Update Package is the same as the currently
installed version.
Software application name: BCM57810 10 Gigabit Ethernet rev 10 (p2p1)
Package version: 08.07.26
Installed version: 08.07.26
BCM57810 10 Gigabit Ethernet rev 10 (p2p2)
The version of this Update Package is the same as the currently
installed version.
Software application name: BCM57810 10 Gigabit Ethernet rev 10 (p2p2)
Package version: 08.07.26
Installed version: 08.07.26
Continue? Y/N:Y
Y entered; update was forced by user
Executing update...
WARNING: DO NOT STOP THIS PROCESS OR INSTALL OTHER DELL PRODUCTS
WHILE UPDATE IS IN PROGRESS.
THESE ACTIONS MAY CAUSE YOUR SYSTEM TO BECOME UNSTABLE!
....................................................................
……………………………………………………………………………………………………………..
Device: BCM57810 10 Gigabit Ethernet rev 10 (p2p1)
Application: BCM57810 10 Gigabit Ethernet rev 10 (p2p1)
Update success.
Device: BCM57810 10 Gigabit Ethernet rev 10 (p2p2)
Application: BCM57810 10 Gigabit Ethernet rev 10 (p2p2)
Update success.
Would you like to reboot your system now?
Continue? Y/N:Y

Qlogic QL45212 Specifications

General

Brand	Qlogic
Model	QL45212
Category	Adapter
Language	English