Chapter 4 Basic Operation Guide
4.1 Power on
Note: Please make sure the power supply matches DVR and AC
cable connected correctly. Before switch DVR on, please connect
one monitor with VOUT or VGA interface. Otherwise, you can not
see graphic user interface and can not operate.
If [POWER] lamp is off, please do as following:
Step1: Connect AC cable correctly;
Step2: Switch on the power button on the real panel.
If [POWER] lamp is in red, just press [POWER] button to start DVR.
When DVR is started, [POWER] lamp is in green. On the monitor or VGA
display, DSP and HDD initialization process will be shown.
The first line represents DSP initialization. If the DSP icon is “×”, it means
that the DSP is initialized error, please contact administrator at once.
The second line represents HDD initialization. Icons of IDE1 master and
slaver HDDs, IDE2 master and slaver HDDs, etc are displayed. If the HDD
icon is “×”, it means the corresponding HDD is not installed or not
detected. If HDD is not detected, please contact administrator.
Note: If HDD is not installed or not detected, DVR will beep for
alarm. You can disable the alarm option in “Exceptions” menu.
To Next Page
Loading...
General