5.3 Unit Name and Device ID
Unit name
In the “Display” menu:
There is an item named “Unit Name”. The default unit name is “Embedded
Net DVR”. Move “Active Frame” to unit name edit box, press [EDIT] key to
enter into edit status, you can modify the unit name. About how to input
characters, please refer to chapter 3.4. Press [ENTER] key to finish
modification. Select “Confirm” button and press [ENTER], you can save
the new unit name and make it into effect. Press “Cancel” button or [ESC]
key to abort modification.
Device ID:
When you use IR Remote Controller to operate DVR, you must use device
ID to select DVR. The default device ID of DVR is “88”. If there are more
than one DVR in one place, please define different device ID for each DVR.
Otherwise, the IR Remote Controller will control all DVR with the same
device ID at the same time.
To Next Page
Loading...
General