Quectel Smart EVB G5 User Manual

Smart Module Series
Smart_EVB_G5_User_Guide 61 / 66
Communication via USB
Step 1: Turn on the module according to the procedures in Chapter 5.1.
Step 2: Connect Smart EVB G5 with PC using USB cable through USB interface and then run the USB
flash disk on PC to install the USB driver and ADB driver. The USB port numbers can be viewed
in Device Manager of the PC when the USB driver is installed, as shown below.
Figure 48: USB Ports
Step 3: Open CMD tool: “START” → “All Programs” → “Accessory” → “Command Prompt”.
Step 4: Use the “adb shell” command to make the module enter ADB mode. Then customers can use
USB ADB interface for testing.
Figure 49: “adb shell” Command

Quectel Smart EVB G5 Specifications

General

Brand	Quectel
Model	Smart EVB G5
Category	Control Unit
Language	English