82
26.6. List of commands computer - balance
Function RESET INTERFACE
Command R CR LF (zero actual orders, restore factory setting)
Function SEND ALL COMMANDS FROM THE BALANCE
Command PC CR LF (all recorded information in commands in the balance
programme are sent from the balance)
Function SEND THE RESULT IN BASIC UNIT
Command S CR LF (result is sent from the balance in basic interval after stability)
Function SEND RESULT IN BASIC UNIT IMMEDIATELY
Command SI CR LF
Function SEND THE RESULT IN ACTUAL INTERVAL
Command SU CR LF (result in actaul unit is sent from the balance after stability)
Function SEND RESULT IN ACTUAL INTERVAL IMMEDIATELY
Command SUI CR LF
Function ZERO THE BALANCE
Command Z CR LF (set the balance to zero after it reaches stability)
Function ZERO IMMEDIATELY
Command ZI CR LF
Function TARE WHEN STABLE
Command T CR LF
Function TARE THE BALANCE IMMEDIATELY
Command TI CR LF
Function SWITCH CONSTANCE TRANSMISSION OFF IN BASIC INTERVAL
Command C0 CR LF
Function SWITCH CONSTANCE TRANSMISSION IN BASIC INTERVAL
Command C1 CR LF
Function SWITCH CONSTANCE TRANSMISSION OFF IN ACTUAL INTERVAL
Command CU0 CR LF
Function SWITCH CONSTANCE TRANSMISSION ON IN ACTUAL INTERVAL
Command CU1 CR LF
Function NUMBER OF THE BALANCE
Command NB CR LF
To Next Page
Loading...
Need help?
General
