Raynor ControlHoist CMT User Manual

8
3.2 Installation
Trolley operators are designed to be mounted directly over the center of the door. The operator tracks should clear the
door by approximately 2.5”. Off center mounting may be required, for example, because of potential interfering
structures. It is possible to install the operator slightly off the center on torsion spring doors. Extension springs require
center mounting.
For technical support, please call 1-800-4-Raynor (1-800-472-9667) or visit www.raynor.com
1
Establish the center of the door
2
Establish the highest point of door travel
3
Position the U-shaped wall bracket
Center of the door
Highest point of door travel
U-shaped wall bracket
Secure wall bracket to header using the
appropriate anchors for your type of wall.
Wall fixation holes
4
Attach tracks to U-shaped wall bracket
Allow the motor to rest on the floor and raise the
front end of the rails and secure with the bolts and
nuts (do not tighten).
Bolt 3/8-16
Nut 3/8-16
Wall bracket
Track
Lock Washer 3/8
Door center
Highest point
2.5”

Raynor ControlHoist CMT Specifications

General

Brand	Raynor
Model	ControlHoist CMT
Category	Door Opening System
Language	English