NU692_7_G2-FRA.qxd 30/09/04 15:32 Page 2.41
J84 - MEGANE SCENIC - NU692-6
C:\Documentum\Checkout\NU692_7_T2-ENG.win 24/11/2004 20:04
- page 41
2.41
PARKING PROXIMITY SENSOR
Operating principle
Proximity sensors located in the
rear bumper “measure” the distance
between the vehicle and an obstacle
when reversing.
This measurement is indicated by
beeps which become more frequent
the closer you are to the vehicle,
until they become one continuous
beep when the obstacle is
approximately 25 centimetres from
the vehicle.
Note: make sure that the ultrasonic
sensors are not blocked (dirt, mud,
snow, etc.).
Operating faults
When the system detects a fault a
beep sounds for 5 seconds as a
warning when reverse gear is
selected. Contact your RENAULT
Dealer.
This function is an
additional aid which
indicates the distance
between the vehicle and an
obstacle when reversing by means
of audible signals.
Under no circumstances should
it replace vigilance and
responsibility on the part of the
driver when reversing.
The driver should always pay
attention to sudden events which
may occur when driving: always
ensure that there are no moving
obstacles, such as a child, animal,
pram or bicycle, etc., or small,
narrowobjectssuchasstonesor
bollards, in your path when
manoeuvring.
To Next Page
Loading...
Need help?
General
