Forwarding
123
4
Programming an End Receiver
This section describes how to program an End Receiver.
Important
❒ One end receiver can be registered for each special sender. To register two or
more end receivers, use group destination. However, a maximum of 500 des-
tinations can be specified in a group.
A Press [Facsimile Features].
B Press [Administrator Tools].
C Press [Forwarding].
D Press [On].
If there is an End Receiver already programmed, a receiver name is shown. If
you want to change the receiver, press [Receiver] and proceed to step
E
.
To cancel Forwarding, press [Off]and proceed to step
F
.
E Specify an End Receiver using the destination list, and then press [OK].
The receiver name is shown to the right of [Receiver].
Press the key on the right of the display to switch the destination between fax
number, e-mail address, IP-Fax destination, and folder.
Set a folder destination in Address Book Management under Administrator
Tools in the System Settings menu. See “Registering Folders".
If you have specified a folder for forwarding, you can specify the file format
used for forwarding. See “Parameter Settings” (switch 21, bit 3).
If you make a mistake, press [Clear] before pressing [OK], and then try again.
F Press [OK].
G Press the {User Tools/Counter} key.
Reference
p.125 “Parameter Settings”
p.217 “Registering Folders”
To Next Page
Loading...
Need help?
General
