Facsimile Features
130
4
Changing the User Parameters
This section describes how to set parameters.
Important
❒ Access to some User Parameter Settings may require options, or other settings
may need to be made beforehand.
❒ It is recommended that you print and keep a User Parameter list when you
program or change a User Parameter.
❒ Do not change any bit switches other than those shown on the previous pages.
A Press [Facsimile Features].
B Press [Administrator Tools].
C Press [Parameter Setting].
D Select the switch number you want to change.
E Select the bit number you want to change.
When the bit number is pressed, the current value switches between 1 and 0.
Repeat from step
E
to change another bit number for the same switch.
F Press [OK].
To cancel these settings, press [Cancel]. The display returns to that of step
D
.
G Repeat step
D
through step
E
to change the switch settings.
H After all the settings are finished, press [Exit].
I Press the {User Tools/Counter} key.
To Next Page
Loading...
Need help?
General
