System Settings
68
2
❖ Program / Change / Delete LDAP Server
Program the LDAP server to find up e-mail destinations in the LDAP server
Address Book directly. This function is possible when sending scan files by e-
mail using the scanner or fax function.
To start an LDAP search, make sure that the items listed below are set. For
other items, check your environment and make any necessary changes.
•Server Name
•Search Base
•Port No.
• Search Conditions
• Authentication method selection
To use the LDAP server in Administrator Tools, select [On] under LDAP server.
This function supports LDAP Version 2.0 and 3.0. Ver 2.0 does not support
High Security authentication.
❖ Use LDAP Server
Specify whether or not to use the LDAP server for searching.
The default setting is Off.
When Use LDAP Server is set to Off, [Search LDAP] will not appear on the
searching display.
❖ AOF (Always On)
Specify whether or not to use Auto Off.
The default setting is On.
❖ Firmware Version
You can check the version of the software installed in this machine.
❖ Network Security Level
For details about this function, consult your administrator.
❖ Reduce Recovery Time
You can specify whether or not to shorten the recovery time.
The default setting is Off.
If you press [On], the recovery time is shortened.
If you press [Off], the recovery time is lengthened and the machine's power
consumption is reduced.
This setting appears only if the copier unit and hard disk are installed in the
machine.
❖ Delete All Logs
For details about this function, consult your administrator.
❖ Transfer Log Setting
For details about this function, consult your administrator.
❖ Unauthorized Copy Control
For details about this function, consult your administrator.
To Next Page
Loading...
Need help?
General
