Administrator Tools
71
2
To enter the search base
This section describes how to enter the search base.
A Press [Change] under “Search Base”.
Select a route folder to start the search from e-mail addresses registered in the
selected folder are search targets.
B Enter the search base.
For example, if the search target is the sales department of ABC company, en-
ter “dc=sales department, o=ABC”. (In this example, the description is for an
active directory. “dc” is for the organization unit, and “o” is for the company.)
Search base registration may be required depending on your server environ-
ment. When registration is required, unspecified searches will result in error.
Check your server environment and enter any required specifications.
C Press [OK].
To enter a port number
This section describes how to enter a port number.
A Press [Change] under “Port No.”.
Specify the port number for communicating with the LDAP server. Specify a
port that is compliant with your environment.
B Enter the port number using the number keys, and then press the {q} key.
When SSL is set to [On], the port number automatically changes to “636”.
To start SSL communication
This section describes how to specify SSL communication.
A Press [On] under "Use Secure Connection (SSL).
Use SSL to communicate with the LDAP server.
To use SSL, the LDAP server must support SSL.
When SSL is set to [On], the port number automatically changes to “636”.
SSL setting must be enabled on this machine. For details, consult your net-
work administrator.
To Next Page
Loading...
Need help?
General
