Printable GL/2 Files
127
4
❖ Font
The font attribute selects the font that determines the rendering style. The ta-
ble below shows the character sets that the HP-GL/2 filter can use. If an un-
usable font is specified, the default font is applied.
Font Selection condition Note
Courie The character set is 0, 277 or
the font is 3
Symbol The character set is 22, 278
Zaps Dingbats The character set is 300, 332,
364, 396, 428
User font The character set is 531 Fonts downloaded using the
DL command.
Mincho / Gothic The character set is 101, 43,
1000 or a higher number; or
the font is 81, 152, 153, 154,
155, 156
Conditions of usage by Min-
cho / Gothic depends upon
the command parameter.
Stick font The font is 48, 49, 50
Helvetica The font is 4
Times Roman The font is 5 and the line
width is other than 3, 7
Times Bold The font is 5 and the line
width is 3 or 7
Times Italic The font is 5, the tilt is 1, and
the line width is other than 3,
7
Times Bold Italic The font is 5, the tilt is 1, and
the line width is 3, 7
Palatino-Roman The font is 15 and the line
width is other than 3, 7
Palatino-Bold The font is 5 and the line
width is 3, 7
Palatino-Italic The font is 15 and the tilt is 1
Palatino-Bold-Italic The font is 15 and the tilt is 1
and the line width is 3 , 7
NewCenturySchlBk The font is 23 and the line
width is other than 3 , 7
NewCenturySchlBk-Bold The font is 23 and the line
width is 3, 7
NewCenturySchlBk-Italic The font is 15, the tilt is 1, and
the line width is other than 3,
7
To Next Page
Loading...
Need help?
General
