Rigol DS7000 Series User Programming Manual

Chapter 2 Command System RIGOL
MSO7000/DS7000 Programming Guide 2-3
:SINGle
Syntax
:SINGle
Description
Sets the trigger mode of the oscilloscope to "Single". This command functions the same as
either of the following two operation: press SINGLE on the front panel; or send
the :TRIGger:SWEep SINGle command.
Remarks
 In the single trigger mode, the oscilloscope performs a single trigger when the trigger
conditions are met and then it stops.
 When the waveform recording function is enabled or the recorded waveforms are
played back, this command is invalid.
 For the single trigger, you can use the :TFORce command to generate one trigger by
force.
:TFORce
Syntax
:TFORce
Description
Generates a trigger signal forcefully. This command is only applicable to the normal and
single trigger modes (refer to the :TRIGger:SWEep command). This command functions
the same as the FORCE key in the trigger control area of the front panel.

Rigol DS7000 Series Specifications

General

Brand	Rigol
Model	DS7000 Series
Category	Test Equipment
Language	English