91
Settings
You can specify the time signature at which the metronome
will sound.
When you record your own performance, it will be recorded
with the time signature you specify here.
1.
Press the [Function] button.
2.
Press the [Metronome] button.
fig.d-bEat.eps
When you release your finger from the button, the
currently selected time signature will be displayed.
3.
Press the [-] [+] buttons to select the beat.
fig.d-beatValue.eps
When you change the rhythm or the Internal song,
the beat of metronome is changed.
You cannot change the metronome beat while a
song or Rhythm is being played.
You can restore the settings you’ve changed on the FP-4 to
their factory-set condition. This operation is called “Factory
Reset.”
When you perform a Factory Reset, all the settings
you have stored will be erased, and the FP-4 will
return to the factory-set condition. This operation will
not restore the contents of internal memory to the
factory-set condition.
Refer to “Initializing Internal Memory” (p. 90).
Executing “Factory Reset” results in deletion of the
registration settings. If you want to keep any data
you have stored, use the “Bulk Dump” operation to
save the data to an external sequencer (p. 104).
1.
Turn the volume to the minimum, and press the
[Power] switch to turn off the power.
2.
Hold down the [Function] button, and press the
[Power] switch to turn on the power.
Continue holding down the [Function] button until “Fct”
appears in the display.
fig.d-FctryRst.eps
“Fct” appears in the display. Then, the screen goes back
to normal.
Metronome Setting
Changing the Beat of Metronome
Indication
Beat Indication Beat
2/2 6/4
Weak beats only 7/4
2/4 3/8
3/4 6/8
4/4 9/8
5/4 12/8
NOTE
Other Settings
Restoring the Factory-set Condition
(Factory Reset)
NOTE
NOTE
FP-4-e.book 91 ページ ２００７年５月２４日 木曜日 午後７時１０分
To Next Page
Loading...
Need help?
General
