13
Getting Ready to Play
Restoring the Factory Settings (Factory
Reset)
To ensure the XV-5080 operates correctly as described in the procedures found in the
Owner’s Manual when using the XV-5080 for the first time, be sure to restore the
settings to their initial status as shipped.
fig.00-011.e_80
1
Press the [SYSTEM/UTILITY] button, getting its indicator to
start blinking.
* If the indicator is steadily lit, you are in SYSTEM mode. Press the [SYSTEM/
UTILITY] button once again, so the indicator is blinking.
2
Press the [F6 (Menu)] button to select Menu 3.
3
Press the [F1 (Factory)] button.
The Factory Reset page will appear.
fig.00-011a.e_80
4
Press [F6 (EXEC)] to execute the Factory Reset.
If you decide not to execute Factory Reset, press the [EXIT] button.
After the Factory Reset operation has been executed, the PATCH PLAY
page will appear.
* The message “Write Protect ON” may appear in a window. If you want to continue
with the Factory Reset, press [DEC] to set Write Protect to “OFF,” and press [F6
(OK)] to close the window. Then press [F6 (Factory)] once more to execute the save.
Once set to “OFF,” Write Protect remains disabled until the power to the
instrument is turned off.
If any important data you
may have created is stored
in memory, then running
this operation will cause
such data to be lost. If there
is any data you wish to
retain, then save the data to
a commercially available
memory card or external
MIDI device.
For more information
about the Internal Write
Protect, please refer to
Owner’s Manual; p. 205.
To Next Page
Loading...
Need help?
General
